NEW PRODUCTS TO POWER YOUR BUSINESS
Stainless Triplex Plunger Pumps
CAT PUMPS recently introduced two new stainless steel triplex
plunger pumps featuring a 316 stainless steel liquid-end for
corrosion resistance. The 7CP6111 and 7CP6171 are designed for
pumping liquids like seawater in small seawater reverse osmosis
installations, demineralized water for misting, or hot water and
sanitizers for sterile cleaning systems. The 7CP stainless steel
pumps offer the flexibility of either belt-drive or direct-drive bell
housing mounting. Both pumps provide a compact, space-saving
footprint and deliver 10. 5 gpm of up to 2,000 psi.
The 7CP6111 pump (shown here) features a single-shaft, direct drive
1,750 rpm, while the 7CP6171 features a single-shaft belt drive of 1,450 rpm.
Preassembled motor pump units are also available with either a 10-hp or 15-hp
motor. ( www.catpumps.com)
Rugged Servo
Inclinometer
UK-based Sherborne Sensors has
introduced the LSI series of closed-loop gravity-referenced servo
inclinometers to the North American
market. The family of inclinometers
is specially designed to withstand
severe shock and vibration inputs
for precise measurements in
demanding environments.
The series incorporates a unique,
flexure-supported torque-balancing
system that is rugged enough to
withstand shock inputs of up to
1,500 g, but which still provides
accuracy and repeatability over a
wide operating temperature range.
Sensor components and associated
electronics are contained within
IP64 environmentally sealed
housing. Units are available in
ranges of ± 14. 5 degrees, ± 30
degrees, and ±90 degrees and
offer a high-level, 5-volt analog
DC-output signal, proportional to
sine of the angle of tilt. LSI series
models are fully self-contained and
can connect to a DC power source
and a readout or control device to
form a complete operating system.
( www.sherbornesensors.com)
Microprocessor-Based Vibration Amplifier
Sensing and monitoring systems supplier Meggitt PLC launched the Endevco model
6634C, a microprocessor-based vibration amplifier that has been designed to
condition and display rotating machinery data in simultaneous outputs, such as
broadband, acceleration, velocity, and displacement.
Model 6634C is designed to accept inputs from a single-ended, differential
piezoelectric or ISOTRON (IEPE-type) accelerometer, velocity coil, or remote
charge converter. Full-scale AC and DC output ranges, as well as sensitivity, are
user-programmable in selectable engineering units, representative of acceleration,
velocity, or displacement. Programming is accomplished from the front panel
keyboard or optional RS-232 computer interface. Units also have an optional
six-pole filter, which may be programmed from the front panel. Up to 10 unique
setups can be stored and recalled from the nonvolatile memory, while two TTL-compatible latched alarm outputs provide both warning and alert functions. An
optional 19-inch mounting rack from Meggitt Sensing Systems can accommodate
up to six units. ( www.endevco.com)
